global_topnav_logo.jpgglobal_topnav_view_cart_off.jpg
global_topnav_below_buttons.jpg
View All
By Brand
By Size
Car Audio

View All


View All
By Brand
By Power

Enclosures
Complete Kits
Pre-Finished
Car Enclosures

Enclosures
Complete Kits
Car Audio

Home Theater
Audiophile

Accessories

Installation / Calibration
Custom Enclosures

Projects


Adire Audio
Extremis 6.8



Kyle Richardson's Speaker Stands   


GALLERY:
Click thumbnails for larger views.

These speaker stands were built for my center surround speakers and stand at 33". The top and bottom are made with 3/4" MDF while the sides are constructed from 7/8" solid mahogany. The front/rear are made with 1/2" MDF and are recessed in 1/2" from the front/rear edge of the sides. A 1/4" deep x 1/2" wide dado was cut on the mahogany sides to allow for the front/back to fit snugly into. Most edges were chamfered with a 45 router bit. The center column is hollow which allowed me to fill it 3/4 full with playground sand to stabilize it and lower its center of gravity. All MDF was painted with eggshell black while the mahogany is stained with Minwax mahogany gel stain and covered with 3 coats of Deft clear gloss finish. Total project time was 3 days off and on with most of the time being taken allowing the stain and clear coat to dry between coats.






(435) 730-4967 1375 W. 3275 S. Perry, UT. 84302 Send questions to:
[email protected]

© 2003 Acoustic Visions, LLC
All Rights Reserved